W.NR. 1.2311

Main characteristics and applications

Pre-hardened plastic mould steel with hardening penetration up to 400mm, with good polishing and texturing properties. This steel is suitable for nitriding (around 800 HV), chrome and nickel PVD plating.

Used for plastic moulds with excellent surface finishing properties. It is also used for mould frames, plates, dies box, etc.

Comparable standards


Chemical composition (typical; in weight %)

CSiMnP (max)S (max)CrMo

Critical points

Ac1 740 °C

Ac3 820 °C

Ms 310 °C

Production technology

EAF – LF – VD - Forging – Heat treatment QT

US specification

In according to standard EN10228-3 Class 4 and standard SEP 1921 Class E/e

Delivery condition

WW.NR. 1.2311 is delivered in quenched and tempered condition, with hardness range 280 - 325 HB (29 - 35 HRC).

Physical properties (reference values)

Thermal expansion coefficient (10-6/K)12.112.412.914.1
Thermal conductivity (W/mk)
Young modulus (Kn/mm2)212205200175

Heat treatment

AnnealingHeat to 700 - 720 °CMin. H.T. for 2 minute /mmAir or furnaceIn order to obtain hardness lower than 250 HB ( 24 HRC) to improve machinability
Stress relievingHeat to 560 - 600 °C (max 30 °C below tempering temperature)Min. H.T. for 2 minute /mmAir or furnaceTo be carried out after machining, is recommended to eliminate the residual stresses induced by mechanical working
HardeningHeat to 860-880°CMin. H.T. for 1 minute /mmPolymer-
TemperingIn the range 550 – 600°CMin. H.T. for 3 minute /mmAir or furnaceTo be carried out after hardening. 2nd Tempering must be performed to max 30°C below tempering temperature

C.C.T. curve


Tempering curve


Tool and Die Steel Includes Cold Work Steel, Hot Work Steel, Plastic Mould Steel, High Speed Steel. These tool materials adhere to great quality demands of steel like temper, strength, toughness, resistance to tempering, hardening capacity, dimensional stability etc. The range of Tool Steel in our store includes products from renowned manufacturers.